Mail Index
[Prev Page][Next Page]
- Fw: Any PCI specs violation? -- a prove on its vaiolation
- From: "Weng Tianxiang" <wtx@umem.com>
- RE: Any PCI specs violation? -- a prove on its violation
- From: "Francois Barlow" <fbarlow@matrox.com>
- cash by fax info
- From: cashbyfax22222@aol.com
- Ref. Doc. for "#" for active low
- From: Philip Decker <pdecker@wavewireless.com>
- RE: Problems with i21154 bridge
- From: Shepard Bob-G14751 <Bob.Shepard@motorola.com>
- Want to quit the list
- From: nabaut@attglobal.net
- Re: Ref. Doc. for "#" for active low
- From: "J. J. Farrell" <jjf@bcs.org.uk>
- Problems with i21154 bridge (II)
- From: Jose Franciso Toledo Alarcon <Jose.Toledo@cern.ch>
- FW: Problems with i21154 bridge (II)
- From: Jim Sather <jsather@sbs.com>
- PCI bus loading
- From: "Nguyen, Son N." <snnguyen@cp10.es.xerox.com>
- No Subject
- From: "david" <ndavid@eth.net.in>
- RE: PCI bus loading
- From: "Ingraham, Andrew" <Andrew.Ingraham@compaq.com>
- No Subject
- From: "david" <ndavid@eth.net.in>
- Fw: a VHDL puzzle
- From: "Weng Tianxiang" <wtx@umem.com>
- Re: Fw: a VHDL puzzle
- From: Kevin Normoyle <Kevin.Normoyle@Eng.Sun.COM>
- Re: Fw: a VHDL puzzle
- From: "Weng Tianxiang" <wtx@umem.com>
- Re: a VHDL puzzle
- From: "AL Pham" <alp_jm@yifan.net>
- RE: Ref. Doc. for "#" for active low
- From: Shepard Bob-G14751 <Bob.Shepard@motorola.com>
- Looking for PCI Utility software
- From: Jeff Siegel <jeff@optosphere.com>
- a VHDL puzzle
- From: "Weng Tianxiang" <wtx@umem.com>
- RE: Looking for PCI Utility software
- From: "Jim Boemler" <boemler@vnet.ibm.com>
- RE: a VHDL puzzle
- From: Tom Curran <tom_curran@memecdesign.com>
- RE: Ref. Doc. for "#" for active low
- From: Philip Decker <pdecker@wavewireless.com>
- Re: Fw: a VHDL puzzle
- From: Neal Palmer <neal@dinigroup.com>
- CPCI Mechanicals
- From: Al Keyworth <Al.Keyworth@measurementcomputing.com>
- Tval test circuits
- From: Robert Lindsell <robertl@research.canon.com.au>
- PCI Bus Master DMA
- From: SHIBU BABY <shibub@nestec.net>
- RE: Looking for PCI Utility software
- From: Dave New <NewD@esi.com>
- RE: Tval test circuits
- From: "Ingraham, Andrew" <Andrew.Ingraham@compaq.com>
- air-gap for esd fingers of compact PCI boards
- From: Ted Firlit <firlit@utmc.aeroflex.com>
- Sensing Interrupt Pins that is not in your trace?
- From: "Addison Chen" <addison@netconvergence.com>
- PCI-X I/O pads
- From: "Vikas M" <vikas_mj@yahoo.com>
- RE: Sensing Interrupt Pins that is not in your trace?
- From: Horkel Milan <m.horkel@decros.cz>
- RE: PCI-X I/O pads
- From: "Ingraham, Andrew" <Andrew.Ingraham@compaq.com>
- RE: PCI-X I/O pads
- From: Ganesan Viswanathan <ganesanv@ami.com>
- RE: PCI-X I/O pads
- From: "Olaf Birkeland" <Olaf.Birkeland@fast.no>
- RE: PCI-X I/O pads
- From: Neal Palmer <neal@dinigroup.com>
- RE: Sensing Interrupt Pins that is not in your trace?
- From: Lame Brooks-G14738 <brooks.lame@motorola.com>
- Re: Sensing Interrupt Pins that is not in your trace?
- From: "J. J. Farrell" <jjf@hal.com>
- Re: PCI-X I/O pads
- From: "Ajit Madhekar" <ajit@controlnet.co.in>
- RE: Sensing Interrupt Pins that is not in your trace?
- From: "Ingraham, Andrew" <Andrew.Ingraham@compaq.com>
- Freely programmable Arbiter
- From: "Sebastian Schoenberg" <schoenbg@lycos.com>
- Re: PCI-X I/O pads
- From: Amit Shah <amits@agere.com>
- RE: Looking for PCI Utility software
- From: "ofer magazanik" <e-m-law@zahav.net.il>
- Unidentified subject!
- From: prabhala rajendra <rpraghuram@yahoo.com>
- PCI - decoupling of unused 3.3V connector pads
- From: tony@burched.com.au (burched - tony burch)
- RE: PCI - decoupling of unused 3.3V connector pads
- From: "Ingraham, Andrew" <Andrew.Ingraham@compaq.com>
- testing tools
- From: Frederic Khoury <kfrederi@CAE.CA>
- Re: PCI - decoupling of unused 3.3V connector pads
- From: Ted Firlit <firlit@utmc.aeroflex.com>
- Re: testing tools
- From: Barbara Aichinger <barb@futureplus.com>
- Re: testing tools
- From: Manfred Kuhland <man@atlantek.com.au>
- miniPCI Type III Connector?
- From: Philip Decker <pdecker@wavewireless.com>
- USB standard
- From: "Anand Acharya" <anandacharya@controlnet.co.in>
- RE: USB standard
- From: "Ingraham, Andrew" <Andrew.Ingraham@compaq.com>
- question for programming the DMA controller
- From: "Zhang Jun" <zhjun@sd.mech.tohoku.ac.jp>
- Re: question for programming the DMA controller
- From: "Weng Tianxiang" <wtx@umem.com>
- VHDL Simulation Model
- From: Mike Jadon <mikej@umem.com>
- Ref Design
- From: Goran Grbic <grbic@mosaid.com>
- Disconnect With Data Even if not a Burst?
- From: Louis Przebienda <lprzebienda@acromag.com>
- Re: Disconnect With Data Even if not a Burst?
- From: Amit Shah <amits@agere.com>
- target single data
- From: "Daniel DeConinck" <daniel.deconinck@sympatico.ca>
- PCI Bus Layout Question
- From: "Markou, Pete" <Pete.Markou@GD-CS.COM>
- PCI cards (PCB only) length
- From: "Dr. Gerhart Hlawatsch" <ghl@scitel.de>
- Re: target single data
- From: "Weng Tianxiang" <wtx@umem.com>
- RE: PCI Bus Layout Question
- From: "Ingraham, Andrew" <Andrew.Ingraham@compaq.com>
- Can you send me the PCI local bus specification revision2.1?
- From: Arun Kumar A D <aarun@cisco.com>
- NMI on PCI
- From: Bob Smith <bsmith@sudleyplace.com>
- Re: NMI on PCI
- From: Tom Keaveny <tak@rtl.rose.agilent.com>
- RE: NMI on PCI
- From: Lame Brooks-G14738 <brooks.lame@motorola.com>
- pci - ide controller
- From: "BANESHWAR M SHANBHAG" <baneshwar.s@lycos.com>
- Re: pci - ide controller
- From: Dimiter Popoff <tgi_earth@yahoo.com>
- RE:NMI on PCI
- From: "John Bush" <john_b@bvmltd.co.uk>
- RE: NMI on PCI
- From: "Ingraham, Andrew" <Andrew.Ingraham@compaq.com>
- Re: pci - ide controller
- From: "Frank Story" <frank.story@acoustictech.com>
- Re: NMI on PCI
- From: Bob Smith <bsmith@sudleyplace.com>
- Question on VPD
- From: "Deepesh Tiwari" <deepesh@us.ibm.com>
- $10,000 UnSecured Credit!!! ezybm
- From: ukqbpaomtrppkmcb@springer.de
- $10,000 UnSecured Credit!!! zegbw
- From: buczmkehrdxqszpq@springer.de
- Hot-Plug PCI / Hot-Swap PCI
- From: James Murray <jmurray@triscend.com>
- Inexpensive PowerPC PCI Bridge/Memory Controller
- From: Marc Reviel <marc@powerlogix.com> (by way of Daniel Weaver <dan.weaver@znyx.com>)
- GSYNC problem
- From: Goran Grbic <grbic@mosaid.com>
- No Subject
- From: "Ramasubramanian,S" <SRamasubramanian@Corvis.com>
- Bridge versus Simple Device
- From: James Murray <jmurray@triscend.com>
- PCI Device Status Register
- From: Manfred Kuhland <man@atlantek.com.au>
- Hot Plug Compliant Silicon
- From: brad yu <bradyu2001@yahoo.com>
- RE: Bridge versus Simple Device
- From: Horkel Milan <m.horkel@decros.cz>
- Re: Bridge versus Simple Device
- From: James Murray <jmurray@triscend.com>
- RE: Hot Plug Compliant Silicon
- From: Lame Brooks-G14738 <brooks.lame@motorola.com>
- No Subject
- From: "Ramasubramanian,S" <SRamasubramanian@Corvis.com>
- Re: Hot Plug Compliant Silicon
- From: Henry Gong <hgong@cisco.com>
- RE:
- From: "Ramasubramanian,S" <SRamasubramanian@Corvis.com>
- RE:
- From: "Ramasubramanian,S" <SRamasubramanian@Corvis.com>
- PnP with MPC107
- From: Marc Reviel <marc@powerlogix.com> (by way of Daniel Weaver <dan.weaver@znyx.com>)
- (No Subject)
- From: "BANESHWAR M SHANBHAG" <baneshwar.s@lycos.com>
- PCI interruptions between two PCI expansion boards
- From: michael.pellegrino@modicon.com
- RE: PCI interruptions between two PCI expansion boards
- From: Richard Walter <rwalter@brocade.com>
- Re: PCI interruptions between two PCI expansion boards
- From: Neal Palmer <neal@dinigroup.com>
- Re: PCI interruptions between two PCI expansion boards
- From: Marco Brambilla <divacon1@sh.bel.alcatel.be>
- PCI I/O buffers expereience
- From: "Amit Agrawal" <amita@lightsand.com>
- Re: PCI interruptions between two PCI expansion boards
- From: "Amit Agrawal" <amita@lightsand.com>
Mail converted by MHonArc 2.4.4