Termination of Bussed signals

["Brijender Mann" <bmann2@ford.com>]

Hi All,
Although this is not directly PCI, it is related (please let me
know if I should post this elsewhere)
*
The CompactPCI spec calls for 10 ohm series termination resistors on all
the
bussed PCI signals.  I assume the value of 10 was chosen based on an 8-slot
CompactPCI backplane.

We are designing a CompactPCI target device that will be in a CompactPCI 
backplane with only two slots.  Does this mean we should use another 
value besides 10 ohms?  Thanks.
*
(posted for Dan Bridges...dbridges@ford.com)
TIA
**************************************************************
*   Brijender Singh Mann                                     *
*       bmann2@ford.com <external>                           *
*       bmann2@eth417.eld.ford.com  <internal>               *
*   Software and Calibration Tools Department                *
*    Electronics Technical Center, Room C360                 *
*    17000 Rotunda Drive, P.O.Box 6010                       *
*    Dearborn, Michigan 48121-6010                           *
*       (313) 390-4153 tel.                                  *
*       (313) 594-7596 fax                                   *
**************************************************************

Ò´¡