[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
REQ64# and ACK64# on passive backplane
- To: Mailing List Recipients <pci-sig-request@znyx.com>
- Subject: REQ64# and ACK64# on passive backplane
- From: Jason Trizna <jbt@mclean.sparta.com>
- Date: Mon, 26 Aug 1996 18:43:24 -0400
- Resent-Date: Mon, 26 Aug 1996 18:43:24 -0400
- Resent-From: pci-sig-request@znyx.com
- Resent-Message-Id: <"oAnx53.0.hV6.aYY8o"@dart>
- Resent-Sender: pci-sig-request@znyx.com
Hi Folks,
I know this goes a little beyond the PCI spec and into the PIC-MG spec but
here goes:
The ACK64# and REQ64# signals are supposed to be pulled up separately on a
passive backplane "for each 32-bit PCI expansion connector", so says the
PIC-MG PCI-ISA Card Edge Connector Proposal for Single Board Computer. What
about on the ISA/PCI SBC slot? What is done with these signals? TIA.
Jason
ƒ L <