Re: Flower Cultivation (3.3V bypassing)

[Ivor Bowden <ivor@peritek.com>]

Yes, it's not recommended, it's required.
Reason is for AC grounding (signal integrity).
Notice the pin out follows signal - signal - gnd - signal - signal - gnd
format, where gnd is an AC gnd, either gnd, 5V, 3.3V, etc. so each signal
is paired with at least one ground.
This was discussed at length here a while back.

At 09:57 AM 2/3/97 PST, you wrote:
>
>Do people really bypass +3V on a +5V-only board as the
>spec (2.1) recommends, or does that fall in the general
>category of "lilly gilding?"
>
>Been-there-done-that, srd
>
>-----------------------------------------------------
>Name: Steve Deiss     E-mail: deiss@sba.cerf.net
>Applied Neurodynamics    619-944-8859  voice
>345 Via Montanosa        619-944-8880  fax
>Encinitas, CA  92024     http://www.cerfnet.com/~deiss
>------------------------------------------------------
>License plates:  D4SBWDU LSN2D4S DDWADD BRMASHV 7734209
>
>Oxymoron: 1. self contradiction, etiology (UK) 'an Oxford Moron,' US
translation - see 'Okygenius.'
>
>
>
-Ivor

--------------------
standard disclaimer:
I speak for myself and my views may not be the same as my employer's.
Ivor Bowden
Peritek Corp
phone: (510) 531-6500
FAX: (510) 530-8563
email: ivor@peritek.com
bp]