[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Series Termination
- To: Mailing List Recipients <pci-sig-request@znyx.com>
- Subject: Series Termination
- From: Brian Hunter <bhunter@srtc.com>
- Date: Tue, 13 May 1997 13:20:50 -0400
- Organization: Sarnoff Real Time Corp.
- Reply-To: bhunter@srtc.com
- Resent-Date: Tue, 13 May 1997 13:20:50 -0400
- Resent-From: pci-sig-request@znyx.com
- Resent-Message-Id: <"ZlJ681.0.Pt3.i9AUp"@dart>
- Resent-Sender: pci-sig-request@znyx.com
A recent class that I took specifically discussed connecting series
terminating resistors of approx. 30ohms to all PCI outputs being driven
onto the bus. However, I did not find anything regarding the use of
series termination in the PCI Spec. My target will be an Altera FPGA
connecting to an SGI O2. What elements should be used to connect to a
33MHz 32-bit PCI bus in order to maintain a clean signal? What about
bidirectional lines--do they get series termination as well?
{