[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Compact-PCI Questions
- To: Mailing List Recipients <pci-sig-request@znyx.com>
- Subject: Compact-PCI Questions
- From: "Bielski, Scott (MED)" <Scott.Bielski@amermsx.med.ge.com>
- Date: Wed, 4 Aug 1999 13:19:44 -0500
- Delivered-To: pcisig@teleport.COM
- Resent-Date: Wed, 4 Aug 1999 11:52:33 -0700
- Resent-From: pci-sig-request@znyx.com
- Resent-Message-ID: <"pq7ol1.0.SS4.EK8gt"@electra.znyx.com>
- Resent-Sender: pci-sig-request@znyx.com
Here are some Compact-PCI questions for the PICMG.
1) I don't understand the nomenclature in the pin numbering section
referring to "the reversal in numbering". Do the connector definitions
in Table 15 refer to the correct number of pins on the connectors or
not? Could I get a sample of this numbering reversal? I am assuming
the following is the correct pinouts for the connectors, however, I
would like some verification on this.
J1 - Z1 GND J1 - Z25 GND
J1 - A1 5Volts J1 - A25 5Volts
J1 - B1 REQ64# J1 - B25 -12Volts
J1 - C1 ENum# J1- C25 TRST#
J1 - D1 3.3Volts J1 - D25 +12Volts
J1 - E1 5Volts J1 - E25 5Volts
J1 - F1 GND J1 - F25 GND
2) I would like the suggested pinouts for connectors J3 - J5. Does the
"numbering reversal" convention apply to these pinouts as well?
Thanks to anyone who can help.