Re: need help on pci design projects

["Peter Marek" <peter.marek@marekmicro.de>]

looks like WinDriver for KrfTech would be a good solution for you:
www.krftech.com

regards,


Peter Marek
General Director
MarekMicro GmbH
Kropfersrichter Str. 6-8
D-92237 Sulzbach-Rosenberg
Germany
Phone: 049 - 9661 - 908 - 210
Fax:      049 - 9661 - 908 - 100
----- Original Message -----
From: ANN WIE WONG <wormworm@hotmail.com>
To: <pci-sig@znyx.com>
Sent: Wednesday, April 05, 2000 4:37 AM
Subject: need help on pci design projects


> hi, my school is working on a pci card design project and i have
encountered
> a few problems. my device would not be a commercial product but sole for
> project purpose. i find that information of designing a pci device is
hardly
> available and was wondering if help can be found here.
>
> my device is required to run under win95/win98 environment. it is prefered
> that my device drivers is written in Visual C++. i have a few questions
and
> was wondering if anyone can help me answer them.
>
> 1)how do i configure my device such that the operating system is able to
> recognise my device. does anyone have any examples or sample codes?
>
> 2)how to send and read data from my device card? what are the commands and
> identifiers to be used? does anyone have any examples or sample source
> codes?
>
> 3)am i able to write data to a physical memory address through the pci bus
> using visual C++ ??
>
> i would greatly appreciate the help given by anyone. thanx.
>
>
> anwei
>
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com