[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: PCI interruptions between two PCI expansion boards

To: <pci-sig@znyx.com>
Subject: Re: PCI interruptions between two PCI expansion boards
From: "Amit Agrawal" <amita@lightsand.com>
Date: Tue, 6 Mar 2001 13:05:41 -0800
Cc: <amita@light033.lightsand.com>
References: <H0020fb916131c31@MHS> <3AA6873D.D4877254@sh.bel.alcatel.be>
Sender: owner-reflector@www.pcisig.com

Hi,

Would any one like to share his expereience in using Nurlogic and Artisan
I/O buffers for PCI-64bit/66MHz. I have following questions:

1. What is typical signal-to-power and ground ratio for die-pad ring for PCI
interface using Artisan/Nurlogic/or other vendor's buffers
2. What type of packages are used ?
3. What is power and ground noise you have seen for these buses?
4. Any references?

Thanks in advance for your response.

Regards,
Amit

References:
- Re: PCI interruptions between two PCI expansion boards
  - From: Marco Brambilla <divacon1@sh.bel.alcatel.be>

Prev by Date: PCI I/O buffers expereience
Next by Date: PCI board outline
Prev by thread: Re: PCI interruptions between two PCI expansion boards
Next by thread: PCI I/O buffers expereience
Index(es):
- Date
- Thread