RE: low cost PCI to local bus bridge

["Joseph Brcich" <jbrcich@juniper.net>]

Also check out the PLX parts. Here is one.

http://www2.plxtech.com/products/9030/default.htm

Joe Brcich
Staff Engineer 
Juniper Networks

-----Original Message-----
From: Peter Marek [mailto:peter.marek@marekmicro.de]
Sent: Wednesday, November 06, 2002 7:32 AM
To: Langus Matevz ITWEH-zunanji; pci-sig@znyx.com
Subject: Re: low cost PCI to local bus bridge


Try QuickLogic QuickPCI parts. Saves you glue Logic on the backend.
These are FPGAs with PCI hard macros on a chip. We have reference IP for an
8bit backend bus available.

regards,

Peter Marek
General Director
MarekMicro GmbH
tel.: 049-9621-9732-110
fax: 049-9621-9732-199
www.marekmicro.de

----- Original Message -----
From: "Langus Matevz ITWEH-zunanji" <langus@iskratel.si>
To: <pci-sig@znyx.com>
Sent: Wednesday, November 06, 2002 4:07 PM
Subject: low cost PCI to local bus bridge


> Dear experts,
>
> can anyone recommend a very low cost PCI 2.2 (target only) bridge to local
> bus (very simple, Motorola or Intel like, can be 8 bits wide).
>
> thanks and best regards,
>   Matevz Langus
>