RE: PCI Clock arising problem

["Mayank Sharma" <mayank.sharma@wipro.com>]

Hi , 

Yes Both PRSNT2 and PRSNT1 signals are grounded ...
Still the clock comes for one cycle and then goes off ?

thanks and regards
Mayank

-----Original Message-----
From: Venkateshwarlu V [mailto:venkateshwarluv@myw.ltindia.com]
Sent: Thursday, January 09, 2003 6:36 PM
To: Mayank Sharma; pci-sig@znyx.com
Subject: Re: PCI Clock arising problem


** Proprietary **

Hi,
Check the PRSNT signals.


Venkat

>>> "Mayank Sharma" <mayank.sharma@wipro.com> 01/09/03 07:01PM >>>
Hi All , 

I am using a PCI daughter card ,If I insert that card into 5V PCI Slot , PCI Clock is not seen in the Logic Analyzer or Oscilloscope , even if we remove the FPGA from the board .....then I see the clock comming up for a short time and then goes off ....afterwards.

If I insert some other daughter card into this same PCI Slot , I can see the PCI Clock , comming to the board....

Can any one help me out in knowing the possiblity of this clock problem I am facing 

thanks and regards
Mayank 

**************************Disclaimer************************************************

Information contained in this E-MAIL being proprietary to Wipro Limited is 
'privileged' and 'confidential' and intended for use only by the individual
 or entity to which it is addressed. You are notified that any use, copying 
or dissemination of the information contained in the E-MAIL in any manner 
whatsoever is strictly prohibited.

***************************************************************************************